![]() ![]() 3.1.2 In which cases can I use pre-shared secret keys (PSK) as authentication method? You can use pre-shared secret keys (PSK), if: MGuard – Frequently Asked Questions 3 VPN 3.1 General Questions 3.1.1 License for 10 VPN tunnels: Does it mean a maximum of 10 VPN tunnels or 10 IP connections? This license limits the maximum number of VPN tunnels that can be configured on the mGuard, not the number of IP connections within a tunnel. This document describes in detail the required steps for configuring the script rollout.sh. 2.3.6 How do I configure the script rollout.sh? Please download the application note mGuard Rollout Support from our homepage (Download AppNotes & Interops). Otherwise this error message can be ignored. 2.3.5 Error message "The system cannot find the file specified (rollout.sh)" The file rollout.sh is only required, if the mGuard should be configured through an atv file during the flash procedure. On Linux: Check the access rights of the directory which contains the image files.Verify that the firmware files image.p7s and 7s are located in the specified update directory.2.3.4 The middle LED flashes red after the DHCP server has sent the IP address Start the TFTP server and ignore appearing error messages.2.3.3 Problems with Windows TFTP/DHCP server The following steps are required if the IP address of the client has been changed regarding the last time you've started the TFTP server: It describes in detail the required steps for flashing the mGuard. 2.3.2 How do I flash the mGuard? Please download the document mGuard Update-/Recovery-/Flash-Procedures from our homepage (Download Documentation). Note: If you want to update the version of the firmware then the Update procedure should be the preferred method. You need to reconfigure the mGuard after flashing the firmware. The mGuard will be restored to the factory (default) settings, also the passwords. ![]() Note that this procedure will erase existing configurations on the mGuard. MGuard – Frequently Asked Questions 2.3 Flash Procedure 2.3.1 When do I need to flash the mGuard? You only need to flash the firmware of the mGuard if the root password is unknown. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |